Materials for necklace making instructions:
Bicone Czech Glass Bead
Silver Lined 8/0 Glass Seed Bead
Brass Jumpring
Brass Eyepin
Nylon Wire
Tools for necklace making instructions:
Side Cutting Plier
Wire-Cutter Plier
Round Nose Plier
How to make your own necklace?
Step1: Make the separate parts of handmade necklace
Assemble the Bicone Czech Glass Beads with Brass Eyepins as small groups.
Group1: Transparent Bicone Czech Glass Bead*1, Brass Eyepin*1(4 groups)
Group2: Green Bicone Czech Glass Bead*1, Brass Eyepin*1(4 groups)
Group3: Light green Bicone Czech Glass Bead*2, Brass Eyepin*1(6 groups)
While grouping well the above groups, leave about 7~8mm length of the brass eyepins, then cut off the excess part and make loops with the Round Nose Plier.
Step2: Make the center part of the handmade necklace
Firstly, cut out a 50mm long tiger wire. Unfold the wire and string 3 Silver Lined 8/0 Glass Seed Beads on it; next, thread the both tips together through 2 Transparent Bicone Czech Glass Beads; then, add another 1 Silver Lined 8/0 Glass Seed Bead on each wire tip and cross through 1 extra Silver Lined 8/0 Glass Seed Bead at last.
After tighten the tiger wire, add 2 pieces of the group2 on each wire tip.
To the following group, the beading method is as same as the above one, one seed beads group, one Bicone Czech Glass Bead group… Just notice the arrangement of different color groups. In these necklace making instructions, the order is: Group1 (transparent ones) as the top, Group2 (green ones) on the bottom and the group 3 (light green ones) in the middle.
After assemble all the 12 groups, tie a knot at the end and cut off the excess wire.
Step3: Make the outline part of the handmade necklace
Prepare another section tiger wire, about 50mm as well. As the picture show, firstly restring the starting three Silver Lined 8/0 Glass Seed Beads;
Next, place the semi-finished product on a flat desk and add several Silver Lined 8/0 Glass Seed Beads on each side (the number may depends on your ideal outline of you necklace, commonly, 4~5 pieces are all ok); finally thread the Bicone Czech Glass Bead groups respectively.
Repeat the above process until grouping all branches well.
Step4: Make the connect hole of the handmade necklace pendant
Just string 6~8 pieces of Silver Lined 8/0 Glass Seed Beads on one tip and tie a knot at end.
Step5: Apply the chain to the handmade necklace
After finished the step3, pull the tiger wire tightly and cut off excess part. Then, open the Jumpring and add the chain to the handmade necklace is ok!
So fresh, isn’t it? In the whole processes about how to make your own necklace, notice the position of each Bicone Czech Glass bead group; furthermore, except the knot part, you do not need to pull the tiger wire too tightly. All the illustrations in this necklace making instructions are true and reliable!
0 comments:
Post a Comment